BBB INDUSTRIES
BBB INDUSTRIES
More Information for BBB INDUSTRIES 2030166E
Continue Shopping
 
BBB INDUSTRIES 2030166E  
Out of Stock
Price
Core
Pack
Total
BBB INDUSTRIES 2030166Eclose
<
>
Part image
BBB Industries markets and sells their products under various brand names, including Genco, Vision-OE and Wilson. The product inside the box is the same, no matter what brand name appears on the box.
BBB INDUSTRIES 2030166E Specifications
Connector A Pin Count2 Pin
Connector B Pin Count8 Pin
Control Module IncludedYes
Hydraulic, Electric, or Manual SteeringElectric
Inner Tie Rods IncludedYes
Input Shaft Diameter (IN)0.870
Input Shaft Diameter (MM)22.098
Input Shaft Length (IN)2.940
Input Shaft Length (MM)74.676
Motor IncludedYes
New Or RemanufacturedRemanufactured
Rack Length (IN)55
Rack Length (MM)1397
Total Turns Lock To Lock3
Reman
BBB's Electronic Power Assist Steering (EPAS) Rack & Pinion Remanufacturing Process Includes:
  • Full disassembly and inspection
  • Electrically and electronically tested for input and output parameters
  • New rack belt (where applicable)
  • New boots and seals

Common EPAS Failures
Water Ingression- This occurs when the unit is not properly sealed and water is able to get inside the unit causing contamination, electrical problems and rust.
Belt Failure- Belt driven EPAS racks have an internal belt to transfer the torque from the electric motor to the rack bar via a ball screw assembly. The belt can wear, stretch, strip, or break causing loss of assist.
Torque Sensor Failure- The sensor gives incorrect input data to the Power Steering Control Module (PSCM) leading to improper assist and diagnostic trouble codes (DTC).
Reduced Assist- When values or inputs are not within specification the PSCM can use preprogrammed values to give reduced assist to the driver. A DTS will be set triggering the Mafunction Indicator Light (MIL).


EPAS Programming

Some EPAS units do not require programming. For those that do, these steps should be followed:

1. Vehicle system voltage must remain constant (OE specified) during the reprogram
2. Vehicle electrical system should be functioning properly
  • Battery health and state of charge
  • Connections are clean and cables are in good condition (voltage drop)
  • Alternator charge peformance (this may require a power supply or reflashing charger, do not use a battery charger)
3. Follow all OE re-programming instructions exactly

Attention California Customers - WARNING: Cancer and Reproductive Harm


Attention California Customers - Y

OEM / Interchange Numbers: 19391403

BBB INDUSTRIES Warranty Information:
3 years/36,000 miles