DORMAN 977689
|
|
$145.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$145.79
Total
|
|
|
|
DORMAN 977689 Specifications |
---|
Adjustable | No | Bore Diameter (MM) | 74 | Connector/Terminal Type | Pin | Electrical Connection Type | Male | Fuel Injectors Included | No | Fuel System Type | Gas | Gasket or Seal Included | No | Housing Color | Natural | Housing Material | Aluminum/pbt | Idle Air Control Motor Included | No | Inlet Diameter (MM) | 75.34 | Inlet Quantity | 1 | Inlet Type | Flanged | Installation Hardware Included | No | Mounting Hardware Included | No | Outlet Diameter (MM) | 75.34 | Outlet Quantity | 1 | Outlet Type | Non-flanged | Package Contents | 1 Electronic Throttle Body | Terminal Count | M6 -1.0 | Throttle Body Finish | Natural | Throttle Body Material | Aluminum | Throttle Body Mounted | No | Throttle Body Spacer Included | No | Throttle Body Type | Electronic | Throttle Position Sensor Included | Yes | Venturi Quantity | 0 |
|
|
Features:- Upgraded design - this plug-and-play replacement throttle body features a contactless Hall effect sensor and proprietary Sensor Shield butterfly shaft seal to prevent future failures
- New construction - 100% new aluminum, not remanufactured, for reliability and the convenience of no core charge
- Rigorously tested - complies with Federal Motor Vehicle Safety Standards (FMVSS) and endurance-proven with over 1 million cycle tests
- Trustworthy quality - vehicle try-on tested, and backed by a team of product experts in the United States and more than a century of automotive experience
Experiencing Acceleration or Idling Issues? It Might Not be the Throttle Body!
Poor acceleration, hesitation and other idling issues can be caused by failure of a variety of parts. Use the chart below to help determine which part is causing the problem.
Part | System | Other Symptoms |
Throttle Body | Fuel & Air | |
Mass Air Flow Sensor | Exhaust & Emission | - Difficulty Starting or Turning Engine
|
Air Filter | Fuel & Air | - Dark Filter Media
- Debris in Filter or Filter Box (Change every year!)
|
Fuel Injector | Fuel & Air | |
Vacuum Hose / Connector | Hoses / Lines & Clamps | - Hissing, Squealing or Sucking Sound from Cracked Connector or Hose (Use a Vacuum Tester)
|
Spark Plug or Spark Plug Wire or Ignition Coil
| Ignition | - Increase in Exhaust Emissions
- Visible Wire Damage
- Oil Leak
|
Accelerator Pedal Position Sensor | Interior | - Limp Mode
- No / Delayed Pedal Response
|
![](/Images/MoreInfo/install.png) Installation Tips - Perform OEM Recommended idle relearn procedure. Some applications may require the use of an OBD Scan Tool while others may refer to the Owners Manual.
- A relearn of idle values can be forced by disconnecting the negative battery cable for several minutes in order to clear the electronic control module's memory.
- Several minutes of idling and highway driving may be necessary to relearn idle values. Electrical loads such as headlights, AC, radio, etc. should be turned off while relearning.
- Erratic idle or engine surging after installation of replacement unit may be resolved by putting a load on the engine. If idle evens out after shifting into gear, shift back into park and check idle RPM - perform relearn again if a drivability condition is present.
- Clean intake manifold mounting surface and replace Intake Manifold Gasket, if necessary.
- Inspect Air Cleaner Intake Hose for cracks and proper sealing - replace or repair with Multi-Purpose Sealant, if necessary.
- Check harness for broken wires and wiggle connector to try and reproduce the problem. Replace or clean Connector, if necessary.
- Clear all diagnostic trouble codes from vehicle computer prior to idle relearn.
|
OEM / Interchange Numbers: 95560506200, 99660511500, 99660511501, 99760511500, 99760511501 |
|