ARNOTT
Mehr Informationen über ARNOTT P2986
{Alternative Artikelnummern: P-2986}
weiter einkaufen
 
ARNOTT P2986  
$1,057.79
Preis
$0.00
Kühlernetz
+ In Sätzen von 1 verkauftx1
Verpackung
$1,057.79
Summe
ARNOTT P2986close
<
>
Part image
ARNOTT P2986 Spezifikationen
Luft Anschluss-Größe0.245mm
Luftfeder System Art/Sorteelektrisch
Trockner beinhaltetJA
Full Load Amperage5
maximaler Druck230 Pfund pro Quadratzoll
Beinhaltet MontagehalterungNein
OESJA
Schutzabdeckung beinhaltetJA
Kabelbaum eingeschlossenNein
Betriebsdruck140 Pfund pro Quadratzoll

Arnott's new replacement air compressor P-2986 is from WABCO - the original equipment supplier to Audi. Unlike compressors that are simply modified to fit the vehicle, this compressor was designed by WABCO specifically for the Audi A8 (D4 Typ 4H Chassis) incorporating a high level of integration mechatronics. This high-performance, yet quiet, WABCO compressor includes a maintenance-free integrated air dryer and comes completely assembled from the WABCO factory in Germany with an application specific air line, wiring harness and brackets.


Installation Information

Air Compressor failure is typically the result of a leak or other issue in the air suspension system. To ensure that your new compressor will work without issue, you should do the following, prior to installation:

  • Check for blown fuses and ensure the relay is working properly. A failed Air Suspension Compressor Relay is a top cause of air compressor failure. They normally fail in the “closed” position and should be replaced during compressor installation
  • Check and replace the Air Springs if they are showing signs of cracks, deterioration, moisture, or are leaking. Complete Air Strut assemblies, which include the Mount and Air Spring, can be found in the Strut category
  • Verify that the air line and wiring harnesses are connected without signs of physical damage
  • Ensure that the fittings and valve connections are fully seated and undamaged. Make sure that the air line is secured at the proper depth
  • Check the electrical connections and the orientation of the Ride Height Sensor arms
  • Check all Air Suspension Solenoid connections and fittings; inspect for any cracks or other damage
  • Inspect the air lines for kinks, holes or other damage


Looking To Convert Your Air Suspension To a Coil Over Suspension?

If you like the load-leveling capabilities, or if you tow with your vehicle, then you should repair the original air suspension system.

If not, and you are tired of the high cost of replacing air suspension components, conversion components can be found for most vehicles under the Coil Spring, Strut / Coil Spring / Mount Assembly and/or Suspension Conversion Kit categories, in the RockAuto catalog, depending on the vehicle setup.

Zusätzliche Hilfsquellen

Einbauanleitung
Erstausrüstung / alternative Artikelnummern: 4H0616005A, 4H0616005B, 4H0616005C, 4H0616005D, 4H0616006, P2860

ARNOTT Garantie Information:
Teile, die vor dem 1.7.2023 gekauft wurden - Eingeschränkte Garantie auf Lebenszeit. Teile, die am oder nach dem 1.7.2023 gekauft werden - 24 Monate.
Details zur Garantie