More Information for ULTRA-POWER SP07K1H

Continue Shopping

ULTRA-POWER SP07K1H	Out of Stock Price	Core	Pack	Total	Add to Cart

Point to Zoom

The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole.

Ultra-Power products come from a variety of sources including re-packaged, well-known brands and ISO/TSO/QS certified overseas factories. They share some of the same suppliers as the big brands do but keep costs low to pass the savings on to you.

Benefits of Purchasing a Fuel Pump & Housing Assembly

Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:

Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.

Prevent Premature Fuel Pump Failure

Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:

ELECTRICAL ISSUES

Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:

Use a Fuel System Tester to test pump pressure is within expected range
Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
Check / Replace faulty Fuse(s) and Relay

BEFORE REPLACEMENT

FUEL CONTAMINATION

Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:

Replace Fuel Filter or Fuel Strainer
Empty and clean the tank with Fuel Tank Cleaner
Fill tank with fresh, uncontaminated fuel of appropriate grade

DURING REPLACEMENT

PUMP DAMAGE / OVERHEATING

Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:

Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation

AFTER REPLACEMENT

WARNING: This product contains chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

ULTRA-POWER Warranty Information:
12 Months