Ball Material - Alloy Steel SAE 5140, Housing Material - Carbon Steel SAE 1040
Maximum Outside Diameter (IN)
1.909
Mount Plate Included
No
Mounting Hardware Included
Yes
Mounting Type
Pressed
Nuts Included
Yes
Position(s)
Rear, Rear Lower. For the position specific to your vehicle, refer to the Application tab.
Stud Tapered End 1 Diameter (in)
0.488
Stud Tapered End 1 Diameter (mm)
12.4
Stud Tapered End 2 Diameter (in)
0.661
Stud Tapered End 2 Diameter (mm)
16.8
Stud Thread Diameter (MM)
12.0
Stud Thread Length (IN)
0.764
Stud Thread Length (MM)
19.4
Stud Thread Pitch (mm)
1.75
Tapered Stud
Yes
Washers Included
No
Width (MM)
48.5
Features & Benefits:
Manufactured with high-quality forgings for increased strength and smooth operation.
Chloroprene rubber boot improves durability and prevents premature failure, with cover to protect internal components.
Machined to micron tolerances to guarantee durability and smooth joint operation.
Anti-corrosion protection applied to each part.
Ball-pin 100% crack tested for flaw free material.
Undergo rigorous performance and resilience tests.
Superior ball-pin finish and nylon seat coating for smooth movement and long lifetime.
High specification grease for reduced friction, and smooth operation in all temperatures and conditions.
Videos
Press-In Ball Joint Replacement
Attention California Customers - WARNING: This product can expose you to chemicals including Carbon Black, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
Videos