• Improved design - this suspension stabilizer bar has been redesigned for greater durability than the failure-prone original equipment part
• Upgraded materials - this stabilizer bar is made from solid forged steel to resist failure caused by weakness in the original part's hollow tube construction
• Compete solution - new bushings and installation hardware are included with the stabilizer bar for a complete repair
• Quality tested - this part has undergone try-on, corrosion and material testing to ensure a quality fit and long service life

How To Determine Stabilizer (Sway) Bar Diameter

To determine Stabilizer (Sway) Bar diameter, measure the bar next to the bushing (toward the center of the vehicle), utilizing one of the methods below.

1. Use a digital caliper or micrometer for a precise reading
2. Use an open end wrench that fits snug around the bar, or tighten an adjustable wrench around the bar, and then measure the span opening
3. Wrap a piece of non-stretchable tape (like masking tape) around the bar to get the circumference. Circumference divided by Pi (3.14) = Diameter. In the example below, the tape measured 3 5/8". 3 5/8 = 29/8 = 3.63 inches. Diameter = 3.63/3.14 = 1.15 inches.