GPD 1711895
|
|
$27.89
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$27.89
Total
|
|
|
|
|
|
- Improved design uses higher strength nylon gears coated with superior lubricant, heavier duty motors and redesigned circuit boards to prevent burnouts
- Precision replacements that mount in the existing position without modification
- Plug and play and do not require any programming
- Exceeds the design of OEM motors
- Life cycle tested in excess of 10 thousand hours
- Provide a more durable service life in the HVAC temperature control system
Tip: always make sure that the electrical connections are clean and free of dirt or moisture before connecting together. This will ensure that the new product will work correctly. Troubleshooting a Rear Blend Door Actuator:- Use a multimeter tool to diagnose the system. First, check the ground. When the rear system is covered in plastic, and hard to get to, grounding issues from previous repairs may be the problem.
- Check the voltage supplied by the control head to the blend door. Refer to the manufacturer's wiring diagram. The wires should carry 12V. If the voltage is less than 12V, the control head may be the issue rather than the actuator motor.
- Check the door. Is it stuck? Debris may have found its way into the blend door and wedged itself in between the door and housing, causing it to stick and burn out the motor.
![](/Images/MoreInfo/bulb.png) Which Actuator Do You Need?
RECIRCULATION |
Controls the intake of air into the system, either bringing outside air in or using inside air in recirculation.
![Recirculation](/genImages/recirc.png) |
BLEND |
Controls the temperature of the air flowing from the vents by mixing hot and cold air from the heater core and the evaporator core.
![Blend](/genImages/blend.png) |
MODE |
Controls which vents have air flow, i.e. Floor, Panel or Front, Defrost, or any combination of those.
![Mode](/genImages/mode.png) |
Diagram:
Main vs. Auxiliary
The term "Main" refers to the air flow control of the Front Vents. The term "Auxiliary" refers to the air flow control of the Rear Vents.
Many actuators that control the air flow to the rear vents are still located in the front of the vehicle. Some larger and/or higher end vehicles may have Auxiliary air door actuators in the center console or in the rear of the vehicle.
![](/Images/MoreInfo/doc.png) Additional Resources Troubleshooting Rear Blend Door Actuators on 2002-2014 Ford Expedition
How it Works: Actuators
|
OEM / Interchange Numbers: 1711903, 1711911, 2L2Z19E616BA, 3L1Z19E616AA, 3L1Z19E616AB, F5TZ19E616A, F77Z19E616AA, F87Z19E616BA, YL5H19E616AC, YL5Z19E616AA |
Warranty Information:12 Months |
|