Image is of a typical part(s); part appearance varies by application. Rotors & Drums are sold individually
Brake Disc Type: Vented; Outer Diameter [mm]: 295; Brake Disc Thickness [mm]: 28; Inner Diameter [mm]: 67; Minimum Thickness [mm]: 25,4; Number of Holes: 5; Number of mounting bores: 1; Height [mm]: 64.5
Valeo brake discs conform to the highest quality standards set at an international
level and guarantee maximum safety. A higher material content enables the disc
to withstand the highest temperatures and allows a more homogenous distribution
of heat.
The brake discs use OE technologies which guarantee a high quality of production.
A precise finish eliminates vibrations and guarantees a high level of comfort
during braking.
Installation Tips
Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function