PRO condensers are manufactured to match the exact tube design of the original condenser for a direct replacement fit. PRO condenser brackets are ribbed to increase strength and rigidity for mounting and component support and side members are U shaped to increase rigidity and protection against fin damage from excessive stress.

Should I replace my condenser?
Small tube passages that are designed to make the condenser more efficient also trap debris that cannot be thoroughly removed by flushing. Trapped debris will block condenser passages and restrict refrigerant flow, diminishing the overall heat transfer efficiency of the condenser. Do not take a chance with flushing, always replace the condenser when a compressor fails.

Installation Tips

• Old Refrigerant must be removed from the system in accordance with local, state, and federal laws.
• Replace the A/C System O-Rings / Seals connected to the A/C Condenser to prevent a Refrigerant leak.
• If the new A/C Condenser does not have an integrated drier, replace the A/C Receiver Drier / Accumulator as well. After opening your A/C System, this part becomes saturated with moisture and needs to be replaced.
• After installing the new A/C Condenser, evacuate the system for at least 45 minutes to remove any moisture. Make sure it holds vacuum for at least 5 minutes. If it does not, you may have a leak in the system. Find the leaking component and repair or replace it.
• Recharge the system with the correct amount and type of Refrigerant as specified in your Owner's Manual.