ARNOTT P2830
|
|
$614.89
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$614.89
Total
|
|
|
|
ARNOTT P2830 Specifications |
---|
Air Fitting Size | 0.25mm | Air Spring System Type | Electric | Dryer Included | Yes | Full Load Amperage | 30 | Maximum Pressure | 180 psi | Mounting Bracket Included | No | OES | Yes | Protective Cover Included | Yes | Wiring Harness Included | No | Working Pressure | 170 psi |
|
|
Arnott's new WABCO aftermarket air compressors are manufactured in Germany and tested at Arnott in the USA. Each compressor comes completely assembled with durable powder-coated mounting brackets, new relay, and harness and is ready to bolt in.
It is common for air compressors to burn out because of a leak in an air suspension spring or other component, leaving your air suspension on the ground. Once installed, Arnott recommends checking your system for leaks.
Installation Information
Air Compressor failure is typically the result of a leak or other issue in the air suspension system. To ensure that your new compressor will work without issue, you should do the following, prior to installation:
- Check for blown fuses and ensure the relay is working properly. A failed Air Suspension Compressor Relay is a top cause of air compressor failure. They normally fail in the “closed” position and should be replaced during compressor installation
- Check and replace the Air Springs if they are showing signs of cracks, deterioration, moisture, or are leaking. Complete Air Strut assemblies, which include the Mount and Air Spring, can be found in the Strut category
- Verify that the air line and wiring harnesses are connected without signs of physical damage
- Ensure that the fittings and valve connections are fully seated and undamaged. Make sure that the air line is secured at the proper depth
- Check the electrical connections and the orientation of the Ride Height Sensor arms
- Check all Air Suspension Solenoid connections and fittings; inspect for any cracks or other damage
- Inspect the air lines for kinks, holes or other damage
Looking To Convert Your Air Suspension To a Coil Over Suspension?
If you like the load-leveling capabilities, or if you tow with your vehicle, then you should repair the original air suspension system.
If not, and you are tired of the high cost of replacing air suspension components, conversion components can be found for most vehicles under the Coil Spring, Strut / Coil Spring / Mount Assembly and/or Suspension Conversion Kit categories, in the RockAuto catalog, depending on the vehicle setup.
![](/Images/MoreInfo/doc.png) Additional Resources Installation Instructions
|
OEM / Interchange Numbers: 2123200104, 2123200404, 212320040480 |
ARNOTT Warranty Information:Parts purchased before 7/1/2023 - Limited Lifetime. Parts purchased on or after 7/1/2023 - 24 Months.Warranty Details |
|