GM GENUINE
More Information for GM GENUINE 19420749
Continue Shopping
 
GM GENUINE 19420749  
$356.79
Price
$0.00
Core
+ Sold in packs of 1x1
Pack
$356.79
Total
GM GENUINE 19420749close
<
>
Part image
GM GENUINE 19420749 Specifications
Connector ColorWhite/Black
Connector GenderFemale
Connector ShapeOval
Fuel Sending Unit IncludedNo
Fuel Tank Pressure Sensor IncludedYes
Fuel TypeGas
Gasket or Seal IncludedNo
Housing MaterialPlastic
In Tank or ExternalIn Tank
Internal Or External StrainerInternal
Lock Ring IncludedNo
Mounting Hardware IncludedNo
Outlet Outside Diameter (IN)0.37
Outlet Outside Diameter (MM)9.39
Outlet Quantity2
Outlet TypeQuick Connect
Pump TypeElectric
Regulator IncludedNo
Terminal GenderMale
Terminal Quantity7
Terminal TypeBlade
Top Mount Diameter (IN)5.1
Top Mount Diameter (MM)129.5
Voltage12 vDC
Wire Harness IncludedNo

A GM Genuine Fuel Pump Module is a GM-recommended replacement for your vehicle's original component. The jet pump maintains a consistent fuel level inside the internal fuel pump reservoir. These assemblies may be equipped with quiet Generation 4 turbine pumps with integral strainer socks. This original equipment fuel pump module has been manufactured to fit your specific GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Features:

  • Designed with guide rods to retain proper alignment while reducing pinching
  • Include a reservoir and jet pump to prevent fuel pump starvation when the fuel level is low
  • Most strainers are placed inside the module to help reduce the chance of puncture
  • Acetyl plastic for good high-alcohol fuel tolerance
  • Electrical connections are designed to help eliminate high resistance due to vehicle vibration
Benefits of Purchasing a Fuel Pump & Housing Assembly

Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:

  • Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
  • Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
  • Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
Prevent Premature Fuel Pump Failure

Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:

ELECTRICAL ISSUES
Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:
  • Use a Fuel System Tester to test pump pressure is within expected range
  • Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
  • Check / Replace faulty Fuse(s) and Relay

BEFORE REPLACEMENT

FUEL CONTAMINATION
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
  • Replace Fuel Filter or Fuel Strainer
  • Empty and clean the tank with Fuel Tank Cleaner
  • Fill tank with fresh, uncontaminated fuel of appropriate grade

DURING REPLACEMENT

PUMP DAMAGE / OVERHEATING
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
  • Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
  • If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation

AFTER REPLACEMENT


Warranty Information:
Limited Lifetime