Standard® is the premier professional engine management brand in the automotive aftermarket today. Standard leads the way in advanced automotive technology with more than 40,000 products for complete vehicle coverage.
Features & Benefits:
100% pure copper windings in primary and secondary bobbins improve durability and provide higher resistance to internal shorts and dielectric breakdown
Electronic ignition module profile and feedback signal ensures proper OE fit, form, and function
Thermoplastic housing withstands heat stress for enhanced durability
Internal core made from grain-oriented electrical steel limits loss factor within magnetic circuit to reduce heat that may reduce coil endurance
External core made from oriented silicon steel ensures durability and longevity
Stainless steel spring resists corrosion
Tin-plated brass terminals improve electrical contact and protect against corrosion
High-dielectric epoxy injected into case and pulled into vacuum to eliminate air pockets and prevent moisture intrusion or thermal breakdown
Silicone rubber boot withstands extreme heat to ensure superior insulation
Tips from SMP Technicians
When one ignition coil fails (especially on a vehicle with higher mileage), you should replace all of the ignition coils with a new set. That’s because one worn out coil means the other coils have been subjected to the same extreme heat stress and wear. In the long run, the most cost-effective repair is to replace the full set of coils.
A Closer Look: Standard Ignition Coils
Attention California Customers - Warning: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.
Attention California Customers - Warning: This product contains a chemical known to the State of California to cause cancer.
