Pressure and Return Hoses are pre-assembled with brackets, providing easy installation and reduced installation time compared to replacement versions sold as individual hoses.
Pressure and Return Assemblies are precision engineered to exact fit and includes all necessary additional components required for to ensure that all wearable parts are restored to original condition.
Pressure Hoses exceed original equipment performance standards with a max working pressure of 1,500 psi, a burst pressure rating of 8,700 psi, and a tensile strength of 1,600 lb. which provides exceptional durability and long life.
Every pressure hose is subjected to a high pressure quality assurance test before leaving the factory, ensuring trouble free installation and operation.
Installation Tips
Replace all power steering hoses at the same time, to prevent system contamination
Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
Installation Tips