Einheit mit niedriger Gasfüllung - Langsame Stangenverlängerung
OESpectrum
Wenn Ihr originales Stoßdämpfer / Federbein von einer Fahrwerksfeder umgeben ist, kann das Ersetzen des nackten Einsatz einen Federspanner erfordern, um die Feder und die Halterung (nicht enthalten) sicher aus der originalen Baugruppe zu entfernen und wieder zu verwenden.
Monroe utilizes a low gas design in select units based on the Original Equipment requirements of the corresponding
vehicle, to help deliver like new ride and handling.
Benefits:
OE manufacturers utilize this damper design on vehicles that will be operated under harsh driving conditions, to help ensure durability of the unit
A low gas design exerts less stress on the oil seal
Helps to reduce ride harshness at low piston speeds
Note: Piston rods on low gas units can take up to 2 minutes to extend. Rod reaction can vary between two units of the same design. Once these units are broken in, however, they will provide the same performance.
To check rod reaction on ride control units, follow this process:
Make sure unit is at room temperature
Cycle unit from full extension to full compression 2 to 3 times with the rod facing up
Fully compress unit and allow the rod to extend on its own. This could take up to 2 minutes for a low gas unit. If the unit fully extends to these specs, it is considered fully functional