Rack and Pinion, Rubber Bushings, Sealing Kit, Instruction Sheet
Pressure Port Thread Size
M18 x 1.5
Rack Length (IN)
33.50
Rack Length (MM)
850.90
Return Port Thread Size
M16 x 1.5
Steering Rack Color
Black
Thread Length (IN)
0
Thread Length (MM)
0.00
Tie Rod Ends Included
No
Total Turns Lock To Lock
2.25
Remanufactured; Does Not Include Inner Tie Rods
Cardone's Remanufacturing Process:
Rubber sealing components are replaced
Finished in protective coating to prevent corrosion and rust
Undergoes a factory test drive, simulating extreme operating conditions while verifying all on-car communications
Installation Tips
Replace Power Steering Pressure and Return Hoses when replacing the rack & pinion. Steering hoses can degrade internally and cause contamination in the power steering system, which can damage the new rack & pinion
Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
Bleed the system to prevent noise and extend the life of the steering components
Installation Tips
Videos
Additional Resources