• 100% Brand new cases, motors, gears, butterfly and throttle position sensor
• Many ETBs feature upgraded non-contact Hall Effect sensor technology reducing wear and increasing longevity
• Come complete with the throttle position sensors to meet OE form, fit and function for ease of installation
• 100% Tested in the USA

Poor acceleration, hesitation and other idling issues can be caused by failure of a variety of parts. Use the chart below to help determine which part is causing the problem.

Installation Tips

• Perform OEM Recommended idle relearn procedure. Some applications may require the use of an OBD Scan Tool while others may refer to the Owners Manual.
• A relearn of idle values can be forced by disconnecting the negative battery cable for several minutes in order to clear the electronic control module's memory.
• Several minutes of idling and highway driving may be necessary to relearn idle values. Electrical loads such as headlights, AC, radio, etc. should be turned off while relearning.
• Erratic idle or engine surging after installation of replacement unit may be resolved by putting a load on the engine. If idle evens out after shifting into gear, shift back into park and check idle RPM - perform relearn again if a drivability condition is present.
• Clean intake manifold mounting surface and replace Intake Manifold Gasket, if necessary.
• Inspect Air Cleaner Intake Hose for cracks and proper sealing - replace or repair with Multi-Purpose Sealant, if necessary.
• Check harness for broken wires and wiggle connector to try and reproduce the problem. Replace or clean Connector, if necessary.
• Clear all diagnostic trouble codes from vehicle computer prior to idle relearn.