Drilled and Slotted Black Rotor Set with Ceramic Pads and Hardware
With a Haynes manual, you can do it yourself…from simple maintenance to basic repairs. Haynes writes every book based on a complete teardown of the vehicle. They learn the best ways to do a job and that makes it quicker, easier and cheaper for you. Haynes books have clear instructions and hundreds of photographs that show each step. Whether you're a beginner or a pro, you can save big with Haynes!
Exclusions: (Does not include information specific to hybrid models)
Table of ContentsIntroduction
Chapter 1: Tune-up and routine maintenance
Chapter 2: Part A: 3.7L V6 and 4.7L V8 engines
Chapter 2: Part B: 5.7L V8 (Hemi) engine
Chapter 2: Part C: General engine overhaul procedures
Chapter 3: Cooling, heating and air conditioning systems
Chapter 4: Fuel and exhaust systems
Chapter 5: Engine electrical systems
Chapter 6: Emissions and engine control systems
Chapter 7: Manual and automatic transmissions, transfer case
Chapter 8: Driveline
Chapter 9: Brakes
Chapter 10: Suspension and steering systems
Chapter 11: Body
Chapter 12: Chassis electrical system
Wiring Diagrams
PLEASE NOTE: This manual is intended for gas engine cars (except where diesel is specifically mentioned) built to US specifications. While the manual may be useful for the same make and model of car built for other markets, such vehicles may have different features, especially in areas concerned with safety and emission control.
Looking for help with a specific vehicle system like Electical or Heat & Air Conditioning? Be sure to check out the Tools and Universal Parts tab for more resources!
Installation Tips
Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
Before installing the rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
Apply brake lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function
Attention California Customers - This product contains Antimony Oxide and other chemicals which is known in the State of California to cause cancer ( or reproductive problems).
R1 CONCEPTS Warranty Information:12 months/12,000 miles
Installation Tips
Videos
