Mevotech TTX parts are engineered with cutting-edge technology to be the strongest, most durable parts on the market. Built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks, TTX hub bearing assemblies deliver extreme performance.
Features & Benefits:
Engineered Internals For Optimum Performance: Precision-engineered higher grade rolling elements and optimized geometry to minimize rolling resistance and maximize load distribution
Enhanced Seal For Contaminant Protection: Low-friction, heavy-duty Advanced Quantum Sealing System with a multi-lip profile that provides layers of defense to keep contaminants out and vital grease in
Pre-Filled With Lubricating Technology: NanoCeramic lubricant withstands extreme temperatures, resists corrosion, and retains viscosity; Particles act as microscopic bearings to reduce friction
Zero-Fault Wheel Speed Signal: A molded, abrasion-resistant cord guards against perforation and contaminants at the sensor and plug ends to ensure a faultless signal for ABS and vehicle safety systems
Quick And Easy Installation: Make your installation faster and easier with fastening hardware and torque specifications right in the box
Corrosion Protected: Repel-TEK anti-corrosion coating is applied to every surface, including studs and hardware, to prevent buildup and contaminant intrusion for a longer part life
Increased Durability: Designed with roll forming to lock internal components for a set preload right out of the box; Increased assembly stiffness reduces vibration and improves part life
During installation, use a Torque Wrench to tighten the axle nut to the manufacturer's specification. Do not use an impact wrench as it is easy to over tighten the axle nut. The torque specification can be found in your owner's manual
Symptoms Of A Failing Wheel Bearing & Hub
Wheel hub units are low maintenance parts, but that doesn’t mean they last forever. Uneven road surfaces, heavy driving conditions (such as towing or racing), and under-inflated tires put extra strain on the hub bearing and can lead to premature failure. Common signs of a bad hub unit include:
A humming, rumbling or growling noise that increases with acceleration
A loud constant whining or grinding noise when the vehicle is in motion
Excessive play in the steering wheel
Steering wheel vibration that changes with the vehicle speed or as the vehicle turns
ABS system malfunction
How To Identify The Faulty Wheel Bearing & Hub
It is often difficult to pinpoint which hub unit has gone bad while driving because noise and vibration
travels through the frame of the vehicle. Here are a two tests you can do to help identify which hub unit has gone bad:
Shake Test: Identifying Play or Looseness
Lift your vehicle so the wheel is off the ground
Place your hands on the sides of the tire and try to shake the wheel
Now place your hands on the top and bottom of the tire and try to shake the wheel again
If you feel movement in both directions, you have play in your bearing and it needs to be replaced
Note: If you feel movement when shaking the wheel left to right, but not top to bottom, you could have a worn out tie rod end. Similarly, if you have movement top to bottom, but not left to right, you may have a worn out ball joint.
Spin Test: Identifying Noise or Grinding
Lift your vehicle so the wheel is off the ground and can spin freely
Spin the wheel, in either direction, and listen for a grinding or howling noise
If you hear a loud grinding or howling noise, that increases with the speed of the wheel, you have a failed bearing that needs to be replaced
Note: It is best to test both front or both rear bearings at the same time so you can compare the difference between the two sides. If you have a failed bearing, there will be a noticeable difference in the amount of noise you hear during this test
Videos
Mevotech TTX Wheel Hubs Are Engineered To Be The Most Durable Solution
Take A Look Inside A Mevotech TTX Hub
Why The Ultimate Wheel Hubs For Nissan Full-Size Vans Are Mevotech TTX
Installation Tips
Videos