BSE markets and sells their products under both BSE and Blue Streak Electronics. The product inside the box is the same, no matter what brand name appears on the box.
New
Features & Benefits:
100% Brand new cases, motors, gears, butterfly and throttle position sensor
Many ETBs feature upgraded non-contact Hall Effect sensor technology reducing wear and increasing longevity
Come complete with the throttle position sensors to meet OE form, fit and function for ease of installation
100% Tested in the USA
Experiencing Acceleration or Idling Issues? It Might Not be the Throttle Body!
Poor acceleration, hesitation and other idling issues can be caused by failure of a variety of parts. Use the chart below to help determine which part is causing the problem.
Hissing, Squealing or Sucking Sound from Cracked Connector or Hose (Use a Vacuum Tester)
Spark Plug or Spark Plug Wire or Ignition Coil
Ignition
Increase in Exhaust Emissions
Visible Wire Damage
Oil Leak
Accelerator Pedal Position Sensor
Interior
Limp Mode
No / Delayed Pedal Response
Installation Tips
Perform OEM Recommended idle relearn procedure. Some applications may require the use of an OBD Scan Tool while others may refer to the Owners Manual.
A relearn of idle values can be forced by disconnecting the negative battery cable for several minutes in order to clear the electronic control module's memory.
Several minutes of idling and highway driving may be necessary to relearn idle values. Electrical loads such as headlights, AC, radio, etc. should be turned off while relearning.
Erratic idle or engine surging after installation of replacement unit may be resolved by putting a load on the engine. If idle evens out after shifting into gear, shift back into park and check idle RPM - perform relearn again if a drivability condition is present.
Clean intake manifold mounting surface and replace Intake Manifold Gasket, if necessary.
Inspect Air Cleaner Intake Hose for cracks and proper sealing - replace or repair with Multi-Purpose Sealant, if necessary.
Check harness for broken wires and wiggle connector to try and reproduce the problem. Replace or clean Connector, if necessary.
Clear all diagnostic trouble codes from vehicle computer prior to idle relearn.
Installation Tips