Barra Estabilizadora; Abrazederas; 'Hardware'; y Enlaces de Extremos de la Barra Estabilizadora
Diámetro de Barra Estabilizadora
33 mm
Incluye Enlaces de Extremo y Bujes, Centro Abrazederas, Bujes
The original equipment tubular steel stabilizer bar on specific vehicles fails when moisture and road salt cause corrosion at the bushings. This Dorman OE FIX stabilizer bar is made from solid forged steel for exceptional strength and durability.
Características y Beneficios:
Improved design - this suspension stabilizer bar has been redesigned for greater durability than the failure-prone original equipment part
Upgraded materials - this stabilizer bar is made from solid forged steel to resist failure caused by weakness in the original part's hollow tube construction
Compete solution - new bushings and installation hardware are included with the stabilizer bar for a complete repair
Calidad probada - esta pieza ha sido sometida a pruebas de ensayo, corrosión y materiales para garantizar un ajuste de calidad y una larga vida útil
Cómo Determinar el Diámetro de Barra Estabilizadora
To determine Stabilizer (Sway) Bar diameter, measure the bar next to the bushing (toward the center of the vehicle), utilizing one of the methods below.
Use an open end wrench that fits snug around the bar, or tighten an adjustable wrench around the bar, and then measure the span opening
Wrap a piece of non-stretchable tape (like masking tape) around the bar to get the circumference. Circumference divided by Pi (3.14) = Diameter. In the example below, the tape measured 3 5/8". 3 5/8 = 29/8 = 3.63 inches. Diameter = 3.63/3.14 = 1.15 inches.
Atención Clientes de California - ADVERTENCIA: Cáncer y Daño Reproductivo - www.P65Warnings.ca.gov
Fabricante Original de Equipo / Números de Intercambio: 10257316, 10257317, 10284146, 10287717, 10287944, 10404184, 10413385, 25861193, 25861194, 25861195, 25861196